Clearance of import of metal scrap procedure - Customs - Public Notice No. 158/2016

OFFICE OF THE COMMISSIONER OF CUSTOMS (IMPORT), NEW CUSTOMS HOUSE, BALLARD ESTATE, MUMBAI - 400001. F. No : S/ 26.Mise. 135/2016-17/ Gr. IV/NCH Dated: 21.11.2016 Public Notice No. 158/2016 Sub: - Clearance of import of metal scrap procedure -regarding Attention Of all the importers, Customs Brokers, Warehouse Licensee and the member of the trade is invited to the Board s Circular No. 48/2016-Customs dated 26.10.2016 the above mentioned subject. 2. The following Circulars have been issued by the Board relating to the procedure for clearance Of imported metal scrap namely:- (i) 56/2004-Cus. dated 18.10.2004. (ii) 02/2005-cus. dated 12.01.2005, (iii) 10/2005-Cus. dated 22.02.2005, (iv) 24/2005-cus. dated 24.05.2005, (v) 32/2005-cus. dated 28.07.2005, (vi) 35/2005-cus. dated 22.08.2005, (vii) 28/2007-Cus. dated 14.08.2007 3. The procedure has been reviewed by the Board in the light Of the changed scenario. The Director General of Foreign Trade, Ministry Of Commerce and Industry, Government Of India has issued a Public Notice No. 38/2015-2020 dated 06.10.2016 (followed by a Corrigendum by way of a Public Notice No. 40/2015-2020 dated 25.10.2016) governing import of un-shredded Metallic Waste and Scrap under Para 2.54 of Handbook of Procedures (2015-2020). 4. With the approval of the competent authority, it has been decided by the Board to withdraw the aforesaid Circulars with immediate effect. 5. It has been further decided that the following procedure for clearance of imported metal scrap (both ferrous and non-ferrous) shall be adopted: (i) Import of metal scrap in shredded form will be permitted through all ports/ICDs/CFSs/LCSs without any pre-shipment certificate as per the existing practice. (ii) Import and clearance of un-shredded compressed or loose metallic scrap, shall be subject to the guidelines issued by the Director General of Foreign Trade, Ministry of Commerce and Industry, Government of India under Public Notice No. 38/2015-2020 dated 06.10.2016 (followed by a Corrigendum by way of a Public Notice No. 40/2015-2020 dated 25.10.2016) and as per the following procedure: (a) The consignments of un-shredded, compressed or loose scrap shall be cleared only through those EDI ports where Risk Management Module is operational. These consignments will be subjected to documentary or physical check on the basis of selection done by Risk Management System. (b) The consignments of tin-shredded, compressed or loose scrap shall be subjected to scanning based on risk assessment at Mumbai port where such facilities for scanning is currently existing. (e) ending upon the congestion at the Port/ICD, the availability of manpower and the antecedents or the importer, the concerned Principal Commissioner/Commissioner of Customs, Permit the importer to remove the sealed container at his own risk and cost to his factory under re-warehousing procedure. This would be subject to conditions specified in (a) (b) above. 6. These instructions may be implemented with immediate effect. 7. The difficulties, if any, in implementing these procedures, should immediately be brought to notice of the undersigned. (SUVIR MISRA) COMMISSIONER OF CUSTOMS (IMPORT)