9911796707
TMI BlogStrict compliance of provisions of Electronics and Information Technology Goods (Requirement for Compulsory Registration) Order, 2012 as amended at the time of assessment, registration and examination,X X X X Extracts X X X X X X X X Extracts X X X X ..... Order, 2012 as amended at the time of assessment, registration and examination, reg. Attention of the Importers, Exporters, General Trade and all other stakeholders is invited to Electronics and Information Technology Goods (Requirement for Compulsory Registration) Order, 2012 (hereinafter referred to as RCR Order ) as amended and various clarifications issued by Ministry of Electronics Information Technology (MeitY) in regard to Product Coverage under the said Order. 2. Ministry of Electronics Information Technology (MeitY) has notified RCR Order on 3 Oct 2012. The Order since then has been progressively applied to increasing product categories of Electronic Goods. Presently, it covers electronic / IT goods as available on t ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... d get the product registered with BIS before import in India or should provide an exemption letter from MeitY. The unregistered repaired/refurbished/second hand items should not be allowed to be imported without prior permission from MeitY. In such cases the unregistered products shall be detained by Customs and the matter should be brought into notice of MeitY for necessary action. Therefore, it is again being informed to all concerned to comply with said legal requirements. LABELLING REQUIREMENT: 6. It has been the legal requirement under the said RCR Order that the Standard Mark shall be placed on the product the packaging both. However, if it is not feasible to place the same on the product for size constraints, it ca ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... parts of the notified products? WW the order apply to an item used as a replacement of a faulty unit? The Compulsory Registration Order applies to finished goods and not the spare Part/components used in the manufacturing of the finished goods, unless they are Notified separately as independent products under CRO. Further, the import of the Notified items in CKD (complete knock down) condition is a//owed. However, for the Import of notified goods, 7n SKD (semi knock down) condition, the import should be Allowed on/y to the manufacturer of the end Finished product which are having IEM License for manufacturing the same. If the products are imported in SKD condition, the customs shall ensure that the importer has valid authorization from ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... gistration Certificate (if applicable) in relation to goods covered by Bill of Entry invariably under e-sanchit. 8.2 Assessment officers, Examining Officers and Officers responsible for registration should also ensure that: i. Description of imported goods as declared in the bill of entry is covered by BIS Certificate in terms of all parameters because BIS Certificate is linked to manufacturer, location of factory, product and brand. ii. Standard Mark in the proper form and manner is placed on the product the packaging as mentioned above. iii. Goods on examination are found to be as declared in the bill of entry. iii. RMS instructions are followed strictly. iv. Importer / Customs Broker has uploaded the BIS Certif ..... X X X X Extracts X X X X X X X X Extracts X X X X
|
