9911796707
TMI BlogImplementation of Risk Management System (RMS) in ImportsX X X X Extracts X X X X X X X X Extracts X X X X ..... (INGAU4) from 15.02.19. 3. The objective of the RMS is to strike an optimal balance between facilitation and enforcement and to enable low risk consignments to be cleared based on the acceptance of the importers self assessment and without examination. This will enable the department to enhance the level of facilitation and speed up the process of cargo clearance without compromising the interests of revenue. With the introduction of the RMS. the present practice of routine assessment, concurrent audit and examination of almost all Bills of Entry will be discontinued and the focus will be on quality assessment, examination and Post Clearance Audit of the selected B/Es in order to ensure that the resources of the department are utilized more effectively 4. RMS mechanism. The purpose of RMS is to facilitate a large number of Bills of Entry, which are perceived to be compliant with the Customs Laws and Regulations. Such self assessed B/Es will be processed by the RMS to evaluate the risk in the B/E if any, and duty will be calculated and challan will be generated by ICES based on declaration/ self assessment by the importer. The goods will be ready for out of charge ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... e RMS is rolled out. Though most AEO Bills of Entry will be selected for no assessment no examination based on the importer s self assessment the RMS will select a small Percentage of Bills at random for Assessment/examination Soon after ling a Bill of Entry in the ICES by the AEO, the System will generate the Bill of Entry Number and print a copy of the B/E with the TR6 challan for duty payment The Importer/CB shall proceed to the bank for duty payment (if any) before Proceeding to take out of charge for the goods. Though self assessment facility is given to the AEO importers and examination waiver is also given to them, the Compulsory Compliance Requirem5 (CCRs) (as mentioned in Para-10) for the import of goods must be fulfilled by the Importer/CB before seeking out of charge Therefore it is advisable that the CB/Importer keeps ready all the certificates permits licenses or any other documents which are essential for the clearance of the goods or for availing any duty exemption After goods registration is done in the system the Customs Officer at the docks/sheds will check the marks and numbers of the Consignment (or seal number in the case of FCL Containers) and send the B/E ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... e) Miscellaneous Certificates: For availing specific notification benefit, the Importer is required to submit certain Customs Duty exemption certificates from designated authorities like Directorate General of Hydrocarbons, Directorate of Health Services, Ministry of Defence, et al. Importers must mention the details of all such certificates in the Annexure to the B/E while filing at the ICEGATE/Service Centre. It may please be noted that goods registration cannot be done without proper debit of bonds. As regards undertakings, certificates etc., either the appraising officer/superintendent of customs in the group or the Out of charge officer will verify the documents physically (if required and not covered by eSANCHIT), depending upon the facilitation extended to the B/E. For expeditious clearance of goods, it is necessary that the lmporter/CB is equipped to comply with all the bond- related requirements before filing the B/E and relevant details are given in the annexure flied at ICEGATE/Service Centre to avoid any undue delays. 8. Amendments in B/E and IGM The existing procedure for amendments in the ICES will Continue. Whenever the Importer/CB desires to seek an amen ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... per the examination order given by the Group and the instructions given by RMS along with the suggested CCR. The System of goods registration followed by examination and out of charge will Continue In the case of BilIs of Entry which are not Selected for examination the officers will inspect only the marks and numbers or seal number of the container and integrity of the seal as the case may be, and proceed to give out of charge (OOC) after the Importer/Ce complies with the CCR and produces the required documents In case of Ex-bond Bills of Entry, the OOC will be given by Superintendent (Gond Section). 12. Documents submission: it is essential that all the documents are submitted to the Proper officer (AO/Superintendent) before getting Out of Charge to the goods. in addition to the documents required for CCRs, the following documents whereever applicable shall be submitted by the CB/Importer and docketed after affixing the signature on each of them: (i) The Customs copy of the 8/E [First Check/Finally Assessed) along with the TR6 challan (ii) Copy of the BL and HBL, as the case may be; (iii) Copy of Invoice Packing List: (iv) B/E declaration with GATT d ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... the duty difference voluntarily In case there is no agreement, the formal processes of demand Notices, adjudication etc., would follow. Undue delay in responding to the Consultative Letter may lead to non-facilitation (in any case within 30 days). 14. DATA Quality; The RMS is designed in a manner whereby Importers/CBs giving proper data in the B/E filed will be facilitated. The system identifies the shortcomings in any Bill of Entry and directs such Bills of Entry for action. Hence, the trade can get maximum benefit out of the system by ensuring that the information submitted in alt relevant fields of the Bill of Entry is complete and accurate Where data quality is found deficient, the Importers/CBs would be advised to make improvements in their submissions The Stress is on self assessment of the Bill of Entry which will be processed by the System based on declaration and if found compliant such Bills of Entry may be sent to out of charge Without any action i.e. assessment or examination it hardly needs emphasis that compliance in all its dimensions is in the mutual interest of the Government and the Trade and Industry and it will enable the Government to give increasing level ..... X X X X Extracts X X X X X X X X Extracts X X X X
|
