9911796707
TMI BlogEffective rate for specified goods falling within one or more Chapters imported for manufacture of specified goodsX X X X Extracts X X X X X X X X Extracts X X X X ..... ted at the rate of 30% ad valorem, subject to the following conditions, namely :- (i) in case of import of goods covered by List B of the said Table, the importer furnishes, at the time of importation, to the Assistant Collector of Customs, an undertaking to the effect that: (a) the said imported goods shall be used for the purpose specified above; (b) the importer shall, within three months or such extended period as the Assistant Collector of Customs may specify in this behalf, produce a certificate from the Assistant Collector of Central Excise in whose jurisdiction the factory manufacturing such finished goods is situated, to the effect that the said goods have been used in the manufacture of the said finished goods; and (c) the importer shall pay, on demand, in the event of his failure to comply with (a) and (b) above, an amount equal to the difference between the duty leviable on such quantity of the said goods but for the exemption contained herein and that already paid at the time of importation. (ii) in the case of goods covered by List C of the said Table, - (a) an officer not below the rank of a Joint Director in the Department of Electronics of the Governmen ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... ss cloth (ii) Copper clad Laminates laminated to Nylon, Teflon, Polyester Printed Circuit Boards. 16. 70 (i) TV Glass Bulbs/Shells (ii) CRT Glass Bulbs/Shells (iii) Magnetron Glass Bulbs/Shells Television Picture Tubes, Cathode Ray Tubes or Magnetrons. 17. 85 Resistor elements/chips with TCR 5 ppm per degree centigrade Chip Resistors/Bulk Metal Film Resistors or Bulk Metal Resistors. 18. 28 Selenium Rectifier Plates of Grade E-25 Selenium TV Rectifiers. 19. 84, 85 Ferrite Permanent Magnets unmagnetised blanks for Ferrite Permanent Magnets DC Micromotors up to 13.5 volts and not exceeding 20 watts rating. 20. 71 Synthetic quartz crystal blocks and blanks Mounted Piezoelectric crystals, 21. 39 Flexible folding disk jacket with liner Floppy diskettes. 22. 39 Glass epoxy or/and polya-mide pro-pregs Multilayer printed circuit boards, copper clad laminates. 23. 48, 76 Kraft paper/tissue paper or aluminium foil for voice coil Loudspeakers. 24. 48, 59 Lint free towels/paper ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... ips for electronic applications. 12. 74 Copper foils (plain or adhesive coated) Copper clad laminates of phenolic or glass epoxy types, multilayer printed circuit boards. 13. 38, 85 (i) Getters (ii) Tungsten coils Electronic valves and tubes. 14. 40, 59 (i) Bungs Electrolytic capacitors, tape deck mechanisms. (ii) Rubber Pinch rollers with or without plastic bush 15. 72, 73 Solder Plated copper plated steel wires of dia 0.04 mm to 1.1mm Capacitors, resistors (other than heating resistors), RF/IF coils, lead tabs. 16. 28, 34, 39, 48, 61, 68, 70, 82, 84, 85 (a) Mica and Micualex washers Semiconductor devices, silicon (in all forms) Hybrid Microcircuits. (b) Abrasive powder (c) Parts of doping systems (d) Plastic film for wafer dicing (e) Sputtor targets (f) Etch disc (g) Film Template (h) Special Gases: (i) Hydrogen chloride (ii) 100%silane (iii) Ammonia (iv) Dichlorosilane (v) Argon (vi) Etch gas ( ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... evices, Silicon (in all forms). 4. 48, 59, 84 (i) Denim Paper (ii) Filter Cartridges (iii) Filter elements Magnetic Tape, Capacitor Grade Metallised Plastic Films, Connectors, Relays, Switches, Printed Circuit Boards. 5. 85 (i) Parts of Rotor Assembly, i.e. unwound rotors including commuter Bush and Speed Governor assembly (ii) Commutator assembly or parts thereof (iii) Brush assembly or parts thereof (iv) Mechanical speed governor assembly or parts thereof DC Micromotors upto 13.5 volts and not exceeding 20 watts rating. 6. 74, 85 Rayon or Silk cover Litz wire in the followisng sizes, namely :- (i) 24 (strands) x 0.03 mm (diameter of each strand) (ii) 12 (strands) x 0.03 mm (diameter of each strand) (iii) 9 (strands) x 0.04 mm (diameter of each strand) (iv) 6 (strands) x 0.04 mm (diameter of each strand) (v) 8 (strands) x 0.03 mm (diameter of each strand) (vi) (strands) x 0.03 mm (diameter of each strand) RF/IF Coils or transformers. 7. 74 Phosphor Bronze wire nettings (60 mesh and above) Cones, Spiders, Dust Caps for Loudspeakers. 8. 28, 29 (i) ..... X X X X Extracts X X X X X X X X Extracts X X X X ..... ing resistors). 21. 39, 59, 73 Screen mesh of stainless steel/ polyester/metallised polyester or nylon (in sizes of mesh 60 or above) Semiconductor devices, printed circuit boards, potentiometers, capacity-ors including ceramic capacitors, hybrid micro-circuits, printed components. 22. 39 Polymide/polymide-amide tape, film or sheet Connectors, capacitors grade metallised plastic films. 23. 37 (i) High resolution, high contrast photographic films and photo stencil films Printed circuit boards, semiconductor devices, potentiometers, capaci-tors, hybrid microcir-cuits, printed compo-nents. (ii) DIAZO (C 6 H 5 N 2 ) Films (iii) Release film for multilayer laminates (iv) Dia positive of screen drawing 24. 39 Heat shrinkable PVC sleeving, tubing, film or ring Capacitors, semiconduc-tor devices, DC Micro-motors, relays, deflection components. 25. 39 Splicing tape Magnetic tape, cassettes. 26. 39, 48, 85 Insulating/taping material (including pocket carrier tape) in tape, roll or strip form with or without adhesive Capacit ..... X X X X Extracts X X X X X X X X Extracts X X X X
|
